SQUID

SQUID

To make squid, you must install item squid in your computer. To installation use command apt-get install squid. Afterward, add new configuration on squid.conf same with bold font.

.....
acl all src 0.0.0.0/0.0.0.0
acl lab1 src 192.168.1.0/255.255.255.0
acl jangan dstdomain www.friendster.com
acl manager proto cache_object
acl localhost src 127.0.0.1/255.255.255.255
acl to_localhost dst 127.0.0.0/8
acl SSL_ports port 443 # https
acl SSL_ports port 563 # snews
acl SSL_ports port 873 # rsync
acl Safe_ports port 80 # http
acl Safe_ports port 21 # ftp
acl Safe_ports port 443 # https
acl Safe_ports port 70 # gopher
acl Safe_ports port 210 # wais
acl Safe_ports port 1025-65535 # unregistered ports
acl Safe_ports port 280 # http-mgmt
acl Safe_ports port 488 # gss-http
acl Safe_ports port 591 # filemaker
acl Safe_ports port 777 # multiling http
acl Safe_ports port 631 # cups
acl Safe_ports port 873 # rsync
acl Safe_ports port 901 # SWAT
acl purge method PURGE
acl CONNECT method CONNECT


……….
# INSERT YOUR OWN RULE(S) HERE TO ALLOW ACCESS FROM YOUR CLIENTS

# Example rule allowing access from your local networks. Adapt
# to list your (internal) IP networks from where browsing should
# be allowed
#acl our_networks src 192.168.1.0/24 192.168.2.0/24
#http_access allow our_networks
http_access allow localhost
http_access deny lab1
http_access allow jangan
# And finally deny all other access to this proxy
http_access deny all

# TAG: http_access2
# Allowing or Denying access based on defined access lists
#
# Identical to http_access, but runs after redirectors. If not set
# then only http_access is used.
#
#Default:
# none

# TAG: http_reply_access
# Allow replies to client requests. This is complementary to http_access.
#
# http_reply_access allowdeny [!] aclname ...
#
# NOTE: if there are no access lines present, the default is to allow
# all replies
#
# If none of the access lines cause a match the opposite of the
# last line will apply. Thus it is good practice to end the rules
# with an "allow all" or "deny all" entry.
#
#Default:
# http_reply_access allow all
#
#Recommended minimum configuration:
#
# Insert your own rules here.
#
#
# and finally allow by default
http_reply_access allow all

# TAG: icp_access
# Allowing or Denying access to the ICP port based on defined
# access lists
#
# icp_access allowdeny [!]aclname ...
#
# See http_access for details
#
#Default:
# icp_access deny all
#
#Allow ICP queries from everyone
icp_access allow all
…………
Then, exit and save this file. Afterward, you must restart squid use command /etc/init.d/squid restart to make reconfigure a squid use command squid –k reconfigure. Now, you can try squid on computer client.